Cadworx Splm Error 7502 Official

Ensure your team actually has a license seat ready for check-out: Open the SPLM utility on your license server. Run a query to view active seats.

Open the (Start > Programs > CADWorx > License Manager).

The SPLM service on the license server machine has stopped or crashed.

: Ensure SPLM was installed prior to the CADWorx installation, as the software requires an established license path to initialize.

The client computer is not properly configured to connect to the license server, or network barriers (like firewalls) are blocking the connection. Troubleshooting & Resolution Steps 1. Verify SPLM Installation and Setup cadworx splm error 7502

: Firewalls or proxy settings may be blocking the connection between the client and the server. Troubleshooting Steps To resolve Error 7502, follow these steps:

Unlike "Feature Not Found" errors (which imply a connection was made but the specific license is missing), Error 7502 usually implies that the license request could not physically reach the server daemon, or the server's response was blocked. The error manifests in the CADWorx application interface during startup or when attempting to access a licensed module.

Verify that the ports required for SPLM communication (often TCP/UDP) are not blocked by corporate hardware firewalls or antivirus software. 3. Review Proxy and Internet Settings

If you're a CADWorx user, you may have encountered the frustrating SPLM error 7502 at some point. This error can be a major roadblock in your workflow, causing delays and disruptions to your design process. In this article, we'll take a closer look at the Cadworx SPLM error 7502, its causes, and provide a step-by-step guide on how to resolve it. Ensure your team actually has a license seat

Ensure you have configured the connection to the correct server IP or hostname. Restart CADWorx to see if the connection establishes. 2. Check Your Firewall Settings

Your computer’s security might be blocking the pdlice.exe program, which handles these license requests. Go to > Allow a program or feature .

The most common solution is ensuring the client is pointing to the right place.

: Confirm that SPLM is fully installed and active. If you are using a new machine, you must install and set up the license manager before CADWorx can pull a license . The SPLM service on the license server machine

If you continue to see , it may be time to contact Hexagon Technical Support . Be sure to provide them with the exact error number and a description of the troubleshooting steps you've already taken.

This typically happens when the computer is not correctly configured to communicate with the license server or when the SPLM software hasn't been properly set up before launching CADWorx.

Open a command prompt and ping the license server by name or IP to verify basic connectivity.

If the port test fails, open the Windows Defender Firewall on both the server and workstation. Create an allowing TCP traffic through the designated SPLM port. 4. Refresh the License Seat via SPLM Dashboard