Ts1162 Installation Manual [2021] (REAL)

The TS1162 model number appears on several other products, which may cause some confusion when searching:

The Interlogix TS1162 is a 3-LED arming station (RAS) that serves as a remote interface for controlling your Challenger security system. It connects directly to the system's RS-485 Local Area Network (LAN), enabling you to arm and disarm security areas from a convenient remote location. For installers, the TS1162 is listed in the system's programming manual as a 3-LED arming station; it is recognized within the CTPlus configuration software as a valid Remote Arming Station (RAS) model.

, the general installation procedure for Challenger RAS devices includes: support.firesecurityproducts.com.au Preparation

: The keypad is responding to panel polls correctly.

Dust the exterior vents every 6 months using compressed air. ts1162 installation manual

: Switches 1 through 4 or 5 represent binary numeric values to calculate the final Remote Arming Station (RAS) address number. Standard Map (Switches 1-4) : Address 1 : Switch 1 ON (All others OFF) Address 2 : Switch 2 ON (All others OFF) Address 3 : Switch 1 & 2 ON Address 4 : Switch 3 ON

This guide outlines the physical installation, wiring, and addressing procedures for the TS1162.

If your TS1162 requires data or sensor inputs, route these low-voltage signal cables through the secondary conduit access point. Keep signal lines at least 12 inches away from high-voltage power lines to minimize electromagnetic interference (EMI). 5. System Configuration and Initial Startup

: Remove body retaining screws and detach the body from the base. The TS1162 model number appears on several other

difference on the data lines (if applicable) and ensure a 2-pair twisted cable is used to prevent signal interference.

The TS1162 supports both DIN-rail mounting and panel mounting. DIN-Rail Installation: Tilt the unit slightly backward.

Observe the front panel indicator lights. A solid green light typically indicates normal power delivery.

Connect a normally open (NO) momentary button across the input pin and 0V . , the general installation procedure for Challenger RAS

: Use the provided mounting template to locate screw holes and the rear cable entry point. Ensure the surface is flat and vertical to prevent the base from warping.

When pressed, this trigger signals the Challenger system to release the door lock temporarily without generating a forced-door alarm. 3. Open Collector Output (Door Strike)

Every device on a Challenger RS-485 LAN requires a unique target address to communicate properly. Configure the DIP switches on the rear of the prior to powering on the system.

Connect the wires to the designated terminals on the TS1162 terminal block according to the standard wiring schematics:

This guide is for informational purposes. For full technical specifications, please consult the official ChallengerPlus Installation and Quick Programming Manual .