Simrad Rf300 Installation Manual __top__ (2024)

: Variable frequency signal (square wave) read directly by Simrad/Robertson autopilot computers. Simrad Commercial Setup & Calibration

:

: Connect the two wires to the dedicated "Rudder Feedback" terminals on your Simrad junction box (e.g., J300X, AC10, AC20, or AC42). Brown Wire

: Turn the helm fully to port, measure or verify the physical angle, and save. simrad rf300 installation manual

The calibration function allows the autopilot to compensate for any minor non-linearity in the mechanical linkage between the rudder and the feedback unit, ensuring the displayed and used rudder angles are perfectly accurate. While the exact menu names vary slightly between autopilot models (AP11, AP16, AP20, AP26, AP35, AP50, etc.), the general process remains the same.

: Check the wiring continuity using a multimeter. Ensure the wires are clamped down on the bare copper wire inside the autopilot terminal block, not on the plastic insulation. Routine Maintenance

This long-form article serves as an extended, detailed walkthrough. While this guide covers best practices and technical insights, it is not a replacement for the official . Instead, it is designed to help you interpret that manual, avoid common installation pitfalls, and ensure your RF300 delivers years of flawless service. : Variable frequency signal (square wave) read directly

After installation:

To help me tailor any further technical specifics, could you tell me:

For the most accurate readings, the center of the RF300 should be aligned as closely as possible with the center of the rudder post. The transmission arm features two slots to accommodate the linkage. When the rudder is centered (amidships), the arm should be positioned so the linkage is perpendicular to the centerline of the boat. The calibration function allows the autopilot to compensate

Now, let's get into the installation process. Take your time and follow each step carefully.

If your autopilot display flashes a "Rudder Feedback Failure" or "No Rudder Data" alarm, perform these checks using a digital multimeter:

A: The RF300 comes with a pre-attached 10m (33ft) cable, providing plenty of length for routing from the rudder area to the autopilot computer.